STREET LIGHTING LED WEATHERPROOF FIXTURE.

The LED lighting fixtures are available in neutral white have a uniform illumination, and are designed for interior or exterior use, using an LED arrangements can overcome 400 watts of HID light.

Applications

• Series VB-LED, lighting fixtures designed for use where moisture, dust, dirt, corrosion and vibration may be present or whereThere exists the possibility of water, wind or snow.
  They can be used in ordinary location.
  Lighting fixtures could be used in outdoor industrial facilities, warehouse,
  industrial and maneuver yards, storage rooms, loading docks,
  access roads, public and private roads, public gardens, parking lots,
  loading docks, etc.

Material:

• Body and mounting: Die-cast aluminum.
• Finish: electrostatic powder coating epoxy/polyester.
• minimum thickness 2 mils.
  Saline chamber test to paint according to ASTM B117
  Paint adhesion test according to ASTM 3359
  Resistance to mechanical impacts according to IK09 body, thanks to its
  design that does not have elements susceptible to breakage.
• External hardware: Stainless steel.
• Optical lens: Prismatic polycarbonate impact and high heat resistant.
• Gaskets: Silicone for high temperatures.
• Photocontrol optional IP65 3 PINS.

Characteristics:

• Photometric Distribution: IESNA Type II and Type III.
• Minimal maintenance.
• Instant ignition.
• Operation at low temperatures.
• Low surface temperatures.
• The LED system can save up to 80% in energy costs.
• 50,000 hours of life can provide more than 10 years of lighting
  without maintenance.
• Grounded housing.
• Contains no mercury and hazardous chemical products.
• Operating temperatures: -40ºC up to +85ºC
• Mounting: Stanchion 1 1/4” nominal (Exterior diameter 1.65“ 42 mm)
  1 1/2” nominal (Exterior diameter 1.89“ 48 mm)
  2” nominal (Exterior diameter 2.37” 60 mm)
  With 4 Stanchion screws and +/- 5º adjustment.
• Wet locations
• Raintight
• Initial lumens 5% @ 25ºC.
  Protection against current variations through voltage suppressor category C3 10 Kv line-ground.
  Excellent heat dissipation for a long life of LED, provides the external
  flap design.
  Real performance could vary as a result of the application and environment where
  The lighting fixtures are installed.
  All parameters are designed and measured under laboratory conditions at 25 ºC
  T5 temperature range for safe use in most hazardous environments.
  Factory sealed: Refer to installation instructions for external seal
  requirements.
• Beam angle: 144º x 62º

Compliances:

• UL 1598
  UL 8750 LED
  NEMA 4, 4X, IP65
  CSA C22.2 No 250
  NMX-J-307-ANCE-2017
  NMX-J-627-ANCE-2009
  NMX-J-529-ANCE-2012
  NOM-001-SCFI-2014
  NOM-003-SCFI-2018
  NOM-058-SCFI-2017
  NOM-024-SCFI-2013
  NOM-064-SCFI-2014